Motion Base and Control Loading Installation & Integration Services

Installation and Integration

In most cases, the installation and integration of a feedback control loading or motion base platform system is performed by the customer, following the provided system manual and drawing set.

However, Servos & Simulation offers on-site installation and integration services for system check-out, calibration, and Acceptance Testing. These services are available under a separate contract, and all requirements must be reviewed and proposed to the customer in advance. Scheduling is contract-dependent and coordinated accordingly.

Typically, the customer is responsible for:

Mechanical installation of the control loader
Installation of linkages
Cable and wiring setup

If required by the customer, Servos & Simulation can provide mechanical or electrical engineering support to assist with the project.

---

Acceptance Criteria

For Feedback Control Loader Systems, acceptance is based on the following:

Matching a set of static and dynamic curves from the aircraft, mutually agreed upon by the purchaser and Servos & Simulation
Integration of the system with the simulator Host
Demonstration of software functionality
Confirmation that the simulator can be operated from the cockpit using the control loader

This assumes the purchaser has suitable simulation data available in a timely manner.

---

For Motion Base Platform Systems, acceptance includes:

Verification that the system meets specifications outlined in the ATP provided by the customer
Integration of the motion base with the host system and control loader for FFTD
Demonstration of software functionality

Again, this assumes the purchaser has suitable simulation data available in a timely manner.