6DOF, Motion base platforms, Vr, Virtual reality, Racing sim, Driving sim, Entertainment rides, Gaming

Should a motion platform cost $5k?

In my travels on the internet, I have witnessed DIY’er attempting to make motion base platforms from various items. From drill motors to wood, these systems are ingenious, but in my opinion seem unsafe and will not last over the long term. Let’s explore why… What does it take to build a motion base? At…

Motion Base Platforms and the Flight Simulation Industry

Motion Base Platforms have been apart of the flight simulation industry for a very long time. Longer than one might think… The simulation industry is relatively old (almost 100 years!), but not quite as old as planes have been in the sky. The follow article is an except from wikipedia in regards to the history of…

6DOF, Motion base platforms, Vr, Virtual reality, Racing sim, Driving sim, Entertainment rides, Gaming

Checking in on one of our older installations

Back in 2015, we went to Harris Corp in Melbourne, Florida to check a high angle six axis motion base platform system that we installed in 2003 to inspect it. The customer said that it was working fine and had been in constant use for these years. The system is used for Sea State 6…

feedback control loader, control loading, actuator, FAA Level D, flight controls, simulation, simulator

5 Undeniable Reasons People Hate Motion Platforms

What are some of the reason that people in the simulation industry hate motion platforms? Let’s explore… 1. Cost! Why are they so expensive? 2. Installation… what is required to install a system and what support does it require? 3. Maintenance… Why does it cost so much to operate one? 4. Properly follow motion cues……

6DOF, Motion base platforms, Vr, Virtual reality, Racing sim, Driving sim, Entertainment rides, Gaming

Frequency Response of a Servos & Simulation Motion Base Platform

Over the past decades, Servos & Simulation has produced hundreds of motion bases. Most of them custom… most of them last decades. Recently, we were asked to build a custom motion base with a very specific set of criteria. It needed to be a six axis motion base platform, the CG was offset 40″ from…